A superb ocean cruiser!
"Dragonfly" is a comfortable and very sea-kindly yacht with an excellent specification.
Her outstanding build quality offers all the refinements and safety you need for extended short-handed cruising with a versatile three cabin layout.
We sold this boat when she was new to her current owner and we know her history.
If you are looking for an offshore cruiser this boat should be at the top of your wish list!
Spacious cockpit with large navigation table/shelves and sliding hatch in a high gloss teak below fixed windscreen.
Seats and upper cockpit coaming covered with seamed solid teak.
Helmsman's seat behind the wheel with inlaid Najad logo.
Removable teak grating on the sole.
Steering pedestal with leather covered wheel, engine lever and stainless steel protection bar for the compass.
Engine control panel and instruments.
Cockpit table in lacquered teak.
Flush recesses in the coamings on both sides.
Behind the windscreen there is additional instrumentation.
Integrated grab rails in the curved fiddles of the navigation table.
Two 12 volt plugs and two chart lamps.
The sprayhood, with window
The sprayhood offers a completely protected area at the forward end of the cockpit and with the extension the entire cockpit can be covered.
Cockpit locker under the starboard seat.
Manual bilge pump operated from the cockpit. Electrical bilge pump with both auto-matic and manual switch.
2 x 2" cockpit drains and drains from the seats.
Guardwires with gates
Pushpit with teak seats and outboard bracket.
Sprayhood - with extention/Cockpit cover, Sun awning cockpit cushions
Warps 6 Fender 2 Boathooks
various engine spares
Deck and coachroof are built in sandwich (Divini cell) construction with multiaxial glass fibre reinforced polyester.
Hull and deck are bolted together.
Strengthened glass fibre laminate beneath stressed areas.
Substantial teak capping.
The deck, coachroof and swimming platform are laid with solid caulked teak, laid in silicon to the GRP deck.
10 x portholes in the coachroof.
Two lockers Aft.
Four 32 mm internal deck drains to avoid smears to topsides caused by run off.
The superb interior is handcrafted in selected and unstained African Mahogany, hand polished and varnished to a satin finish. Profile-milled cupboards and doors. The isolated moulding above the berths is lined in Mahogany. Flooring of varnished teak plywood with holly inlay. Removable hatches for the bilge and tank gauges. Headlining of white vinyl covered panels with Mahogany strips.
24 volt, 290 Ah domestic batteries
12 volt converter for instrumentation. 24 volt a/c. 65 amp. alternator.
12 volt, 115 amp.hr. engine battery.
12 volt a/c. 80 amp. alternator.
Well dimensioned electrical cables. The cables are to a large extent run in conduits. Main switch panel with circuit breakers adjacent to navigation table.
The galley is placed on starboard side.
Pressure system with accumulator tank for hot and cold fresh water.
Single lever mixing tap.
Gimballed twin burner gas cooker with oven.
Fixed gas pipes with remote controlled shut-off valve between cooker and gas bottle.
Two well-insulated refrigeration boxes, both with refrigeration units.
Stowage for groceries.
Cupboards with fiddles for plates, cups and glasses.
Cupboard under cooker for pans, etc.
Waste basket under sink.
full set of wooden drawers, one for cutlery.
Cutting board over sink.
Lights over work area.
Corian counter tops
Galley equipped with three burner cooker with oven
Top loading fridges
Stainless steel Double sink
Yanmar 4JH3-HT(B)E 4-cylinder, 4-stroke turbo marine diesel with fresh water-cooling.
Approx 1100 Engine hours
Power output at prop. shaft is 96 h.p. (70,2 kW at 3 800 r.p.m.)
Mechanical reverse gear, type KM4A, reduction ratio 2.63:1.
40 mm propeller shaft in acid resistant stainless steel.
Stern gland with water lubricated rubber bearing.
Flexible shaft connection/ thrust bearing aquadrive.
3-blade folding propeller in bronze with shaft anode.
Single lever engine control at the steering pedestal.
Instrument panel installed in the pedestal containing: - Rev. counter - Engine hour meter - Displays for • low oil pressure • high engine temperature • charging - Audible warning for oil pressure and engine temp - Switch for instrument lights and alarm test - Key
Electrical starter motor, 1.4 kW. Electrical stop.
The engine is suspended in four rubber mounts for effective vibration damping.
Wet exhaust pipe with swan neck and effective rubber silencer.
Well sound insulated engine room.
The engine is easily accessible for servicing.
Fischer Panda generator - Approx. 30 hours
Shore power with ring main, hot water and battry charger
New rudder bearings 2015
TANKAGE 2 fuel tanks - (460 litres) 3 water tanks 2 holding tanks
The hull is built in a sandwich construction and handlaid of multiaxial glass fibre reinforced ISO polyester.
The surface layer is of NGA gelcoat.
The colour is white with Dark blue trim line and water lines laid in the gelcoat.
An integral swimming platform with a bathing and safety ladder in the transom.
The bilge is reinforced with a longitudinal and transverse floor plate construction, which supports keel fittings, mast, engine frame, tanks and cabin soles.
Additional reinforcements longitudinal in the hull as stringers.
All main bulkheads and the trans-verse chain plate fittings are laminated to the hull.
The rubbing strake is combined with the toe rail and is fitted with a brass capping for protection.
Below the water line the hull is treated with epoxy primer and antifouling paint.
The hull is flow coated internally.
Seldén mast in silver anodised aluminium profile 224/150 mm, length 20.65 m stepped on the keel.
Fractional rig with three pairs of swept spreaders, lower shrouds.
Standing rigging replaced in 2012
Pro-furl head sail furler (2010)
removable inner forestay (cutter stay) with adjuster.
Running check stays.
Carbon Fibres Spinnaker Pole.
Two further anchors in Port Lazerette
19-ply stainless steel wire standing rigging. 10 mm forestay and backstay.
12 mm cap shrouds and lower shrouds.
8 mm inner forestay and intermediate shrouds.
7 mm running backstays.
Headsail furling system by Seldén, Furlex 300S/10, reefing line at port, stoppers at the toe rail and organizer to outside of cockpit.
Stainless steel Gibb rigging screws.
7/8” for top and lower shrouds, 1/2" for intermediate shrouds and baby stay.
Stainless stel chain plates, bolted to transverse bulkheads, laminated on both sides to the hull.
Hydraulic, manual controlled backstay adjuster.
The mast is fitted with deck light, steaming light, internationally approved signal horn,
Prepared for spinnaker equipment,
One selftailing stainless steel halyard winchAndersen 46 ST, stopper
Stainless steel reefing winch Andersen 12 ST.
Windex and flag halyards.
Internal main and jib halyards of 7 mm stainless steel wire with Terylene rope end.
Seldén boom in silver anodised aluminium profile 200/117 mm with internal outhaul and double reefing lines with stoppers. Main sheet to two stainless steel sheet winches on a ball bearing car and adjustable sheet point.
Selden bat-cars track and ballbearing sliders
Mainsail - Peterson
Jib - Doyle high-tech
Jib - Peterson
Storm jib - Peterson
2 x stainless steel, electric self-tailing Andersen 58 ST Genoa sheet winches.
2 x stainless steel self-tailing main/spinnaker winches,
Andersen 46 ST. 3 x lockable winch handles, 25 cm.
4 x 40cm stainless steel mooring cleats, through bolted.
2 x 30 cm stainless steel spring cleats, midships, through bolted.
Bow fitting with twin integrated anchor rollers to suit the 30 kg Bruce anchor.
Pulpit and pushpit in 30 and 25 mm acid resistant steel.
Pushpit with two integrated teak seats.
Double lifelines with gates on both sides - five pairs of 30 mm stanchions screwed to fittings, which are through bolted to the rail below the capping.
Folding bathing and safety ladder fitted in the integral swimming platform.
Main sheet track, with trim lines and stop-pers. 3,0 m long
Genoa tracks and variably adjustable sheet blocks.
Windscreen of toughened glass in aluminium frame.
5 x skylights on deck. One of size 387x500, two of size 195x340, one of size 500x500 and one of size 620x620. 10 x portholes in the coachroof sides.
6 x Dorade deck ventilators with stainless steel protection bars.
Deck fillers for water and fuel and for evacuation of the holdingtanks.
International approved navigation lights.
Shower at the swimming platform.
Lewmar electric windlass on deck, 24 volt 1500 W.
30 kg Bruce bow anchor and 80 m x 8 mm HT chain.with s/teel swival
Ensign staff and boat hook.
Hamble Point Marina
Hamble, Southampton, Hampshire